BWS1500 Simple Install Guide
16
Step 12
Verify operation of the Float Switch inside
Storage Tank. Manually raise float (point
upward). The Processor pump will turn off
and the “Tank Full” LED on the Controller will
illuminate.
Lower the float to
restart and resume
normal operation.
Step 13a
Ensure the Storage Tank Outlet Valve and the
Buffer Tank Valve are both open (handle in
line with valve body).
Step 13b
Disable the system: On the Processor
Controller, press and hold the “System Disable
Button” until the “click,” then release. The
“Tank Full” LED should begin flashing (red),
indicating the system is disabled.
Step 13c
While securely holding the 1/2” gray
Optimized Water Line over the Storage Tank
opening, turn the Processor Emergency Bypass
Valve to the “BYPASS” position.
v
Check Tank Float Switch
v
Rapid-Fill the Storage Tank
Float up
Tank Valves
open
Secure Optimized
Water Line
Float down
System
disable
and Bypass
mode