May 2007
11
Figure 10: Some examples of horizontal pipe bends
The pump installed between the outlet of the Bio Chamber and the inlet of.the UV unit.
NOTE!
In order to
prevent the fluid to splash on to the UV light tubes and its fitting, a 45
°
pipe bend must be put on the fluid
inlet on the inside of the UV unit. The pipe bend should be turned towards the bottom of the UV unit. A
reduction between 50 mm and 40 mm diametre should be purchased as well as the 45
°
pipe bend.
Figure 11: Example of an Aquatron 90 / 400 installed with a
pump
