17 |
Housing closing
Housing closing
STEP 1:
Before closing the housing, remove the O-ring seal from its groove and
carefully verify that the O-ring and its groove are free from scratches
or foreign matter. Lubricate the O-ring with a light coat of silicone
grease. Also check that the O-ring mating surface on the housing is
clean and free of any physical damage.
WARNING:
For proper handling of O-rings, follow the detailed instructions
outlined in the Care and maintenance - O-rings section page 30.
STEP 2:
Perform either a Surveyor moisture alarm test or a vacuum check if
you are using a pump. Refer to
Error! Reference source not found.
,
REF _Ref483412315 \h \* MERGEFORMAT
Error! Reference source
not found.
and
Error! Reference source not found.
sections (from page
Error! Bookmark not defined.
) for a complete procedure.
STEP 3:
Be sure that the housing is free of any foreign object that could
interfere during closing.
STEP 4:
Be sure that both locking latches on the rear portion of the housing
are unlocked. If unlocked, latches should be able to rotate freely, if
they cannot rotate freely, unlock them by pressing the locking tab and
pulling them out.
