aquatic Industries, Inc.
1
Maintenance and care
Before tub is used, the whirlpool system should be cleaned and disinfected. Remove all debris and clean tub before
putting whirlpool into service. DO NOT USE ABRASIvE CLEANERS ON THE ACRYLIC FINISH. Use a non-abrasive
detergent and rinse well after cleaning.
• Fill the tub with HOT water to a level 2” above the highest jet.
• Add 2 teaspoons of low-sudsing automatic dishwashing detergent and no more than 4 ounces of household
bleach to the water.
• Operate whirlpool for 10 minutes. Drain.
• Refill with cold water and operate whirlpool for 5 minutes. Drain.
To remove accumulations of bath residue from the whirlpool system, we recommend that you purge it at least twice a
month, or more depending on usage. To do this, follow this simple procedure. Fill the bath with hot water (not exceeding
140
o
F). Add to the hot water, 4 (6) tablespoons of low foaming detergent such as liquid Cascade or Calgonite and 24
(48) oz. of liquid household bleach, such as Clorox [use lesser amounts shown for 5-foot bathtubs, greater amounts
in parentheses for larger bathtubs]. Run the bath for 5 to 10 minutes. Drain the bath completely and refill with cold
water only. Run the whirlpool for 5 to 10 minutes, then drain the bath completely. Depending on the usage and/or the
content of the local water supply, more frequent purging may be necessary.
note: do not use oil or oil based bath additiVes.
If you want to use any kind of bath additive, use only a small amount of low-foaming powder or crystal substance; the
whirlpool action intensifies the foaming properties of soaps.
The use of certain bubble baths and bath additives may increase the level of accumulations of bath residue in the
whirlpool system. If excess accumulations persist, you should discontinue use of these products.
If you have followed the monthly purging instructions and still have an excess accumulation of bath residue and desire an
alternative cleaning mechanism, we recommend
suPer systeMs clean Plus
manufactured by Stearns Packaging
Corporation to rectify this condition. This may be obtained by calling Aquatic Industries, Inc. at (800) 555-5324. It is
recommended that you follow the instructions provided by the manufacturer with the product. Repeated use may be
necessary.
suPer systeMs clean Plus
does not replace the necessity to purge your whirlpool system at least
twice a month with a low foaming detergent and bleach.
Use common household, non-abrasive cleaners for most cleaning jobs. Rinse well and dry with a clean cloth. Never
use abrasive cleaners. Do not allow your Lucite® acrylic surface to come into contact with products such as acetone
(nail polish remover), nail polish, dry cleaning solution, lacquer thinners, gasoline, pine oil, etc. Remove dust with a soft,
dry cloth. Clean grease, oil, paint, and ink stains with isopropyl (rubbing) alcohol.
All Symphony jets are easily removable, and can simply be put into the dishwasher for easy cleaning.
(NOTE: Use top rack and remove before drying cycle.)
S
initial cleaning:
WhirlPool systeM cleaning:
surFace cleaning:
jet cleaning:
Summary of Contents for SYMPHONY SERIES
Page 2: ......
Page 13: ...Aquatic Industries Inc 13 detail view a detail view b ...
