12-PIN HARNESS CONNECTION
The AQ-DM-5UBT includes the universal harness AQ-UNH-2 in order to connect the
dock to power and speakers.
All open wire connections should be soldered and protected against water and dust for best long term
performance.
MOUNTING THE UNIT
1. Mounting templates is included. Aquatic
AV recommends using the ‘measure twice, cut
once’ method.
2. Once the mounting hole is complete, make
sure the outside surface is clean and clear
of debris. The Digital Media Locker has an
external water/dust proof gasket, but this
requires a clean surface for best performance.
3. The Digital Media Locker has six (6) front
screws. Drive the screws using a screw driver.
During final mounting apply equal pressure
to all points for the best water/dust outer seal
performance.
4. Review all outside surfaces of the Digital
Media Locker to ensure proper water/dust seal.
This is important for long term environmental
protection performance for your digital media
device.
REMOTE BATTERY INSTALL
Remove the RF Wireless Remote control from the Digital Media Locker. Unscrew the
waterproof cap on the back of the remote control. Place the CR-2430 battery in the RF
Remote control and replace the water/dust proof cap.
POWER ON
Press the on/off button. Standby will be indicated by a red LED and ON by a blue LED.
For applications that require low current draw and where battery drain may occur, the power button
must be turned OFF. When the power button is in the OFF position the red LED will not be lit.
For applications where a 12V battery is not used, such as in a Spa, the power button can be left ON
and the remote control can then be used to power on/off accordingly.
REMOTE SYNCHRONZING
1.
Turn the Digital Media Locker to standby with the power button inside the door. The LED
should illuminated red.
2. Press the red( ) button on the remote.
3. Press and hold the( ) button until the LCD reads PAIR.
4. Continue to press the
( )
button during step 5 below.
5. Turn the docking station stand by (within 10 seconds) with the on/off button inside door(the red
LED will illuminate).
6. The remote’s LCD should read WELCOME or show a mode position such as RADIO, BT or AUX
IN.
For any additional remote controls, you will also need to activate/synchronize those remote controls
by following the steps above.
If the pairing process is not effective, switch the locker off using the on/off button located
inside the door of the dock. Unplug the 12-pin Harness on the back of the Locker for 3minutes.
Reattach the Harness and repeat steps 1-6 above.
If the LCD displays “NO LINK” in either mode, this means the remote is out of reception
range. Move the remote closer to the Locker and try again.
If you lose your remote control and buy another new remote control, please follow the above
to start pairing before normal usage.