Remove the RF wireless remote control from the Digital Media Locker box. Unscrew the water-
proof cap on the back of the remote control. Place the CR-2450 battery in the RF remote control
and replace the water/dust proof cap.
1.6 Remote Control Battery Install for AQ-RFDM-5BT (optional)
1.7 Remote Control Synchronizing for AQ-RFDM-5BT (optional)
1. Connect the RF Remote Receiever and 8-pin DIN Remote Receiver Cable together.
2. Turn the Digital Media Locker to OFF mode with the power button inside the door. The
LED should not be illuminated.
3. Press the red (POWER) button on the remote.
4. Press and hold the (MODE) button until the LCD reads PAIR.
5. Continue to press and hold the (MODE) button during step 5 below.
6. Turn the docking station to standby mode (within 10 seconds) with the on/off button
inside door (the red LED will illuminate and then turn blue).
7. The remote’s LCD should read WELCOME and then display mode position BT AUDIO or
AUX IN.
For any additional remote controls, you will also need to activate/synchronize those remote con-
trols by following the steps above.
If the pairing process is not effective, switch the locker off using the on/off button located inside the door of the dock.
Unplug the 12-pin Harness on the back of the Locker for 3 minutes. Reattach the Harness and repeat steps 1-6 above.
If the pairing process is not effective, check the battery voltage. If above 3V DC refer to section 1.5 above top make
sure the battery is installed correctly. If battery voltage is below 3V DC replace the battery.
If you lose your remote control and purchase another new remote control, please follow the above to start pairing before
normal usage.
Press the on/off button inside the dock.
Red Light: Power to the docking station is ON, but the unit is in standby mode.
Blue Light: The unit is powered ON and looking for an audio source.
For applications that require low current draw and where battery drain may occur, the power but-
ton must be turned OFF inside the unit. When the power button is in the OFF position the red
LED will not be lit.
For applications where a 12V battery is not used, such as in a Spa, the power button can be left
ON and the remote control or door controls can then be used to power on/off accordingly.
1.5 Power On
Getting Started
Digital Media Locker AQ-DM-5BT
5
www.aquaticav.com
