SOCKET INSTALLATION
Some states and localities require the grounding
of any metal object within five feet of the
pool edge, but this is sometimes difficult in
retrofit versus new installations. Each socket
has a grounding lug on the bottom to connect
to a grounding rod. Electrolysis (staining of
the stainless steel) may result if the lift is not
properly grounded. Consult your local building
codes for grounding information.
The socket is located in the seat box and is
attached under the seat.
A 3” carbide core drill makes an excellent
clean hole in solid concrete. The center line of
the socket hole for your installation should be
_____” from the pool wall or ______” from
the edge of the deck. Drill the hole at least 8”
deep. It is necessary that the top of the socket
be flush with the deck’s surface. With the socket
positioned in the hole
with the notch facing
the water,
use a level to be certain the socket is
plumb and straight, and pour the anchor cement
around the socket. Place a combination square
with level full depth into the socket to assure that the socket is vertical in all directions as the
cement sets (about 15 minutes). Allow the cement to cure overnight before installing the pool lift.
WATER CONNECTIONS
The pool lift is operated by city/household water pressure with no electricity needed.
Our system is designed for most efficient operation at approximately 55-65 PSI operating (open
flow) pressure to lift 400 lb., the maximum lift capacity. Less pressure is required to lift less
weight.
There are several ways to determine your water pressure. You can purchase a 0-100 PSI Water
Pressure Gauge from your local hardware store, or you can ask your water company or fire
department what the pressure is. Be aware that pressure gauges measure the static pressure of a
water line, which is higher than the open flow or operating pressure.
2