14 © 2007-2009 Aquathin Corporation. All rights reserved. Rev 20091029
2) Solder pipes to adaptors
According to your local
plumbing codes, the
installer must identify
appropriate pipes to be
connected to the bypass
valve.
The pipes must be first
soldered onto the adap-
tors as shown in
figure
7
.
3) Screw adaptors into
bypass valve
The adaptors can then
be screwed onto the
bypass valve as shown
in
figure 8.
4)
Re-attach the by-
pass valve
Attach the bypass valve
onto the main control
valve using the provided
clips and tighten the
screws as shown in
fig-
ure 9
.
Doing so, you will be able to measure and approximate
the required length of piping from the bypass valve to the
water source and outlet.
Fig. 7. Solder the pipes to the
adaptors.
Fig. 8. Screw the adaptors back
on the bypass valve.
Fig. 9. re-attach the bypass valve
to the main control valve.
