9
CIRCUIT BREAKER REQUIREMENTS:
A new GFCI circuit breaker must be used for your spa installation. Do not use an existing breaker,
as its condition is unknown.
The 220-240V 50Hz systems use a single electrical service (one 13 amp or one 20 amp breaker)
using 3 wires. The 3 wires are 1 line (brown) + 1 neutral (blue) + 1 protective earth (green/yellow)
ON either system, the spa must be connected to a dedicated GFCI circuit breaker that is not
shared with any other equipment. Do not use extension or plug type cords of any kind.
CONFIGURING SYSTEM
CONFIGURING YOUR SPA TO 13 OR 20 AMP SYSTEM:
When using a 220-240V 50Hz 13 amp or 20 amp system, attach the wires to the terminals as
shown below.
• On a 13 amp system, the spa heater will ONLY work when the pump is in the low speed.
• Using a 20 amp system will allow the heater to work when the pump is in either the low or high
speed.
ELECTRICAL REQUIREMENTS
Blue
Brown
Green
Breaker
IMPORTANT:
After powering up the spa when using a 20 amp system,
a program configuration
is required.
Press and Hold JETS button for 30 seconds to access the Low Level (LL) settings
on the control panel. Use the +/- button to change the setting from LL1 Factory Default (non
concurrent heat and high speed) to LL2 (concurrent Heater and High Speed pump) configuration.
Press the LIGHT button within 25 seconds to save the new program setting.
Summary of Contents for Benicia
Page 1: ...OWNER S MANUAL 220 240V 50Hz Models ...
Page 24: ...304243 16 B 7 16 ...
