7
Problem: The lamp unit has been accidentally
immersed.
Solution: Immediately switch off the mains supply to
the PSU and remove the lamp unit from the water
while holding the unit vertically with the cable entry
end uppermost.
Disconnect the lamp unit from the PSU via the
connector located 150mm/6” from the PSU. If
immersed it is normal for some water to be held
around the outside edge of the lamp unit and this can
be removed by gently shaking the unit vertically and
then drying carefully with a lint-free cloth.
When fully dry, check to see if any water or drips
are visible inside the main body of the unit when
observed through the front lens cover. If you are in
any doubt as to whether water has penetrated the
unit then do not reconnect to the PSU and
immediately return the unit to your local stockist for
further inspection by Tropical Marine Centre.
Please Note: Accidental immersion or
partial/fully submerged installation of the
lamp unit will invalidate the guarantee on the
lamp unit
.
For further information, please see our
website: www.tropicalmarinecentre.co.uk
MiniLED 500 instructions v1-2011_Layout 1 09/11/2011 09
