AquaPRO AS10000DF, Instructions Manual, Page: 3 / 8

HOTLINE
1300 278 283
PHONE
+61 (8) 6260 1000
EMAIL
SALES@AQUAPROONLINE.COM.AU
WEB
WWW.AQUAPROONLINE.COM.AU
AS10000DF PUMP
INSTRUCTIONS
INSTALLATION
• Screw the 90° elbow connector into the pump housing in a clockwise direction. Tighten the elbow
firmly to prevent leakage.
• Prepare the Multiple Hosetail Outlet; it is designed to fit various hoses, pipes and fittings. Three
options are detailed below.
1. To fit a 25mm (1”) tap adaptor (temporary application only) Cut off the first 25mm barbed
section with a hacksaw directly in front of the threaded section. It is now ready to be fitted with a
25mm (1”) tap adaptor (not included).
2. To fit a 25mm hose. No cutting is required; hose or tube is now ready to be fitted.
3. To fit a 32mm hose. Cut off the 25mm barbed and threaded sections with a hacksaw leaving the
32mm barbed section only; hose or tube is now ready to be fitted.
• Screw the prepared Multiple Hosetail Outlet clockwise onto the elbow, tightening firmly to Prevent
leakage. Tubing or hose not to be connected at this stage.
• Fit hose or tube to the prepared Multiple Hosetail Outlet and secure with hose clamp (not supplied).
• Unwrap the power cable and ensure the plug is clear of wet damp locations.
• If required the pump can be immersed in deep water by using a rope secured to the carry handle.
• Adjusting the Float Switch. The float switch allows you to adjust the switching On and Off depending
on the application requirements. The float switch can also be set to run continuously.
AUTOMATIC MODE
• In automatic mode float heights can be adjusted between 500 and
150mm. To control the automatic on/off switching at various water
levels, simply reduce or increase the length of the float switch
cable by inserting the cable into the circular groove (Float Switch
Adjuster) on the side of the carry handle.
MANUAL MODE
• CAUTION: The pump is to be observed at all times during manual
mode. Prolonged use in manual mode may result in a shorter
motor life or burnout. Set the float switch cable into the
circular groove with the float as close to the pump as
possible. To turn on, position the float above horizontal. The
pump will now run continuously until turned off. Turn off by
tilting the float down 30° or switching off at the power point
(GPO).
AQUAPRO AS10000DF Instructions.indd 3 AQUAPRO AS10000DF Instructions.indd 3 3/5/2022 11:53 am 3/5/2022 11:53 am