3
WARNING
Please read this manual carefully before you proceed with the installation. Your failure to follow any
of the attached instructions or operating parameters may lead to the product’s failure and possible
property damage.
Save the manual for future reference.
Thank you for your purchase of this Aquaphor RO. With proper installation and maintenance, this
system will provide you with premium quality drinking water. The technology used in the Aquaphor
RO enriches the filtered water with minerals in controlled quantities.
This water is highly beneficial for the body as it helps to normalize the physiological processes.
If you have any questions or concerns, please contact our customer service department at
email [email protected]. We are always happy to answer any questions you may have regar-
ding our product.
Introduction
Aquaphor RO operates by removing contaminants from water at the molecular level. By using your
household water pressure to squeeze the water against a special membrane, the water molecules
are separated from any impurities that exist.
Rejected dissolved solids are automatically rinsed away through the drain leaving you with only
high-quality, delicious water for your use.
1. Operational parameters
Operating temperatures:
Maximum 38 ºC (100.4 ºF)
Minimum 5 ºC (41 ºF)
Operating pressure:
Maximum 0.63 MPa
(6.3 bar / 91.4 psi)
Minimum 0.19 MPa
(1.9 bar / 27.6 psi)
The operating pressure in your home should be tested over a
24 hour period to attain the maximum pressure. If it is above 0.63
MPa (6.3 bar / 91.4 psi), then a pressure regulator is necessary,
and will be required.
Dimensions (length х height х width):
371 х 420 х 190 mm
Maximum flow rate membrane cartridge
(water tempe25 °С (77 °F)
with a constant pressure of 0.4 MPa
(4 bar / 58.02 psi)
For Aquaphor RO-101S, Aquaphor RO-101S EU,
Aquaphor RO-101S IL – 50 GPD
For Aquaphor RO-102S, Aquaphor RO-102S EU, Aquaphor RO-
102S IL – 100 GPD
Cleaned water to drained water ratio (wa-
ter temp. no less than +20 °С / 68 °F)
1:4-1:6
Mass no more than
6.2 kg / 13.66 lbs
pH parameters:
Maximum 10
Minimum 4
Iron:
Maximum 0.3 ppm
TDS (Total Dissolved Solids):
Maximum 2000 ppm
Turbidity:
Maximum 1 NTU
Hardness:
Recommended water hardness should not exceed 350 ppm as
CaCO
3
(20.5 grains per gallon). The system will operate with hard-
ness over 350 ppm (20.5 gpg), but the membrane cartridge life
may be shortened. The addition of a water softener may lengthen
the membrane cartridge life.
