AQUALEAK EMS-10X, Instruction Manual

Page: 47 / 53

Environmental Monitoring System (EMS-5X, 10X and OS) Instruction Manual
47
5.4 Alarms
If a leak, Cable break, or system fault is detected, the Summary screen will display the number of faults
and/or alarms, as well as a red flashing Active Alarms button and an amber Mute button:
Figure 36: EMS Summary Screen with Alarm Activated
5.4.1 Active Alarms
Active Alarms are displayed on the Alarms screen ( Figure 37 ), where the user may:
Acknowledge individual alarms
Acknowledge all alarms (engineer only)
Refresh the alarm list
Reset relays
In Figure 37 (below), water has been detected in zones 1 and 2 (Interface Board) and the zone relays are
activated (i.e. latched ):
Figure 37: EMS Alarms Screen with Active Alarms Listed
List Active Alarms as follows:
1.
Open the Summary screen (i.e. if on a
different screen).
2.
Tap the red ‘ Active Alarms ’ button
( Figure 36 ). The Alarms screen will display
( Figure 37 ).