06
5. Release Aquaeegg to Water
Importantly, first insert the waterproof cover into the charging port before the Aquaeegg is put into the water.
Tilt the Aquaeegg for 45-degree with the gas outlet of the sensor facing up (as shown below), and slowly place it
into water or pool, to avoid trapping air bubbles inside the sensor. Slowly shake a few times in water to release air
bubble if necessary.
Trick: You can soak the whole Aquaeegg a few inches below the water surface to utilize water pressure to drive out
the air bubbles out of the sensor compartment much easier.
NOTE:
Do NOT put unassembled Aquaeegg device without sensor directly into the water. It will cause damage to the
circuit board.
