Aquaglide Jungle Joe 2 Owner'S Manual Download Page 4

Assembly

1) Locate a flat, dry area with access to electrical outlet or extension cord. The 

best setup position will also make launching easy, so ideally the Jungle Joe tube 

should be carefully carried into position at the water’s edge. NOTE: Dragging 

or sliding the Jungle Joe over ground either before or after inflation can cause 

damage. 

2) Once in the setup/ launch position, unfold the Jungle Joe completely and 

locate the Main Valve. The Main Valve is located on the lower, blue section of  

the product. See diagram for details. 

3) Using a high output pump capable of reaching 1.6 psi (minimum), place the 

inflation hose with proper adaptor into the Main Valve to inflate the main, blue 

section of Jungle Joe. 

Inflate to 2.0 psi (0,138 bar).

 Check for proper air pres-

sure using a manometer. After inflation, replace Main valve cover. Inflation times 

can vary by inflator, but the Jungle Joe should be firm and tight when completely 

inflated. 

DO NOT OVER-FILL. 

Excessively high pressure can cause damage to the 

product and may void the warranty. Carefully monitor air pressure in the product 

especially during hot weather. 

WARNING:

 Do not use an air compressor to inflate tube. Air compressors are 

designed for high pressure inflation and can cause tube to burst if over-inflated. 

WARNING:

 Do not use Jungle Joe without adequate air pressure - 

1.6 p.s.i. 

(0,110 bar) minimum

 in the main bladder. 

4) Next locate the Upper Valve found on the white upper tube near the main 

valve. Follow the instructions and warnings found in Step #3 to properly inflate the 

Upper section. 

Inflate to 2.0 psi (0,138 bar).

  Check for proper air pressure using 

a manometer.

WARNING:

 Do not use Jungle Joe without adequate air pressure - 

1.6 p.s.i. 

(0,110 bar) minimum

 in the upper bladder. 

5) Next locate the Slide Valve found on the slide’s blue sidewall. Follow the  

instructions and warnings found in Step #3 to properly inflate the Slide. 

Inflate to 

1.2 psi (0,083 bar).

  

6) Depending on the application, some users may have purchased an optional 

Swimstep or Runway boarding platform. If you have a boarding platform, connect 

it now using the instructions provided with the accessory. NOTE: It is best to 

 

attach such items while they are deflated. Once fully attached with Interloc straps, 

then inflate. 

7) To launch the product, make sure to have at least 6 people evenly spaced 

around the product to help carry it. NEVER DRAG THE PRODUCT! YOU MUST 

LIFT AND SET TO AVOID ANY ACCIDENTAL TEARING AND/OR ABRASION.

    www.Aquaglide.com

Aquaglide, Inc.    #1 North Shore Dr, SE    White Salmon, WA  98672      TEL: (509) 493-4938      FAX: (509) 493-4966

Anchoring

IMPORTANT: 

Proper anchoring is essential to the safety and performance of

your product. Due to the wide variety of conditions, we advise using a profes-

sional skilled in mooring and anchoring, and experienced with local conditions.  

If improperly anchored, the product can move and/or float away. Aquaglide, Inc. 

is not responsible for any damage, injuries or losses due to improper anchoring.

NOTE: There are 4 heavy duty anchor rings underneath the Jungle Joe. These

rings are located underneath the Main section, near each of the 4 corners.

Due to the high loads that may be generated, you must use AT LEAST 2 of

these rings to spread the load and properly secure the product under normal

conditions.

Main Valve

Upper Valve

Slide Valve

Watersports can be safe and fun for all levels of enthusiasts. The Operator’s Manual is presented to enhance 

your enjoyment of the sport. It is intended to alert you to some of the potentially dangerous conditions that 

can arise in all watersports. It is the owner’s responsibility to read the owner’s manual and instruct all users 

in the safe operation of these products. By inflating these products you hereby agree to the Release of

Liability, Claim Waiver, and Assumption of Risk Agreement in the Owner’s Manual.

To reduce the risk of injury or death, follow these guidelines:

•   Carefully read the product Owner’s Manual and follow the instructions.

•   Take all reasonable precautions in the use and operation of your trampoline and/or aquapark.

•   Teach anyone using your trampoline and/or aquapark about safe guidelines prior to use.

•   Know your own limits. Stop when you are tired. Act responsibly. Be in good physical

    condition and be cautious in your use of this or any other water sports product.

•   Periodically check mooring bridles and/or lines to ensure safety. Replace any portion of

    mooring and/or connection system that shows signs of wear.

•   Do not add any hardware or attachments not otherwise supplied by the manufacturer.

THE WARNINGS AND PRACTICES SET FORTH ABOVE REPRESENT SOME COMMON RISKS

ENCOUNTERED BY USERS AND DOES NOT PURPORT TO COVER ALL INSTANCES OF RISK OR DANGER. 

PLEASE USE COMMON SENSE AND GOOD JUDGMENT.

Please contact the dealer or manufacturer of this product if you have any questions about proper selection, 

function, or safe use of this product.

Made in China

CAUTION

Owner’s Manual

Summary of Contents for Jungle Joe 2








Reviews: