A
B
C
D
12-15mm
from the
bath edge
4x45mm screw
Ф6 drill bit
E
Ф2.75 drill bit
3.5x10mm screw
Step 1
: Position the wall profile (1) onto the bath , approximately 12-15mm from the outside bath edge to ensure that
the screen runs along the inside edge of the bath rim. (A).
Step 2
: Level the profile with a spirit level , then mark the position using a pencil. Mark through the 3 pre-drilled screw
holes in the wall profile. (B).
NOTE :Y
ou may find it easier to mark and drill the wall if you apply masking tape to it first.
Step 3
: Drill the marked points using a 6mm masonry drill bit.
Step 4
: Insert 3 wall plugs (18) into the wall holes , then secure the wall profile using 3 x ST4X45 screws (21). (C)
Step 5
: Carefully position the screen into the wall profile. (D)
Step 6 : Secure to the wall profile using 3 x ST3.5X10 screws (21) and cover caps (6) and (7). (E) (F)
