Whole House Water Filtration System
Product Code: SYS-203-WAWF
Page
7
of
13
REPLACEMENT GUIDE
You can obtain replacements from your local AquaCo dealer. To maintain performance, warranty and standards use genuine AquaCo
replacements.
To maintain the high quality of the purified water the cartridge(s) need changing every 12-18 months (this is dependent on water
quality and usage). You can obtain replacement cartridges from your local AquaCo stockist. To maintain performance and warranty
use genuine AquaCo replacements.
CARTRIDGE INSTALLATION / REPLACEMENT
To change the filter cartridge(s) please adhere to the following procedure:
1.
Turn water supply off and relieve pressure by opening a downstream tap or
pressing the red pressure relief button on the housing(s) (if fitted).
2.
Unscrew the filter bowl(s). If difficult to undo, use the wrench provided. Remove
old cartridge(s). We recommend replacing O-rings every 3 - 5 years to ensure a
water tight seal, preventing any leaks.
3.
Clean bowl(s) with soap and warm water and rinse thoroughly. Check O-Ring(s)
for damage and if there is any, replace.
4.
Check O-ring(s) lubrication and if necessary, apply a light coating of food grade
silicone lubricant (or similar).
5.
Remove all packaging from new filter cartridge(s) and insert into housing bowl(s)
making sure cartridge(s) is properly seated over spigot in base of bowl(s).
Remember to record the model no. of the cartridge(s) you use.
6.
Hold bowl(s) upright while screwing onto head. Make certain that the spigot in
the housing head(s) is located centrally to the cartridge(s) to make a good seal.
Hand tighten bowl until firm.
DO NOT OVER TIGHTEN.
7.
Open downstream tap to allow air to be released and gently open water supply
allowing all air to be purged.
8.
Allow water to run for 2 minutes to flush the system.
9.
Close down stream tap and check for leaks. Flush system for 10 minutes after
any period of non-use more than 2 days. For a period of non-use of 2 weeks or
more, it may be necessary to replace the cartridge.
NOTE: TO RUN UNFILTERED WATER TO THE HOUSE (WHEN GARDENING OR
FILLING THE POOL), PLEASE CLOSE VALVES GOING IN AND OUT OF THE
FILTER SYSTEM (#3 & #7) AND OPEN THE BYPASS (VALVE #9).
Figure 3
Figure 4