1) Fixing Transmitter:
2) Finding location for Indicator Unit:
3) Fixing Indicator Unit:
First of all the transmitter unit has to be fixed as per Fig-
2. Separate arrangements has been shown in figure for overhead
tank transmitter and underground tank level transmitter. Utmost
care has to be taken not to cut/damage/ scratch sensor wires.
Position the sensors as shown in Fig-2. The excess sensor wire
may be coiled and pushed inside Blue Plastic Tube. A black
protective flexibly tube is provided to place it properly to protect
sensor wire from damage by closing the tank cover.
There are 2 short wires black and red color joint together.
Cut/ break them apart so that the transmitter unit will start sending
signal. After placing the sensors you have to get the tank full upto
Full Level Sensor so that transmitter unit will calibrate the sensor.
Now transmitter unit will send the data regarding water level of
tank.
Make power supply connection to the indicator unit as per
Fig-1 and switch on power supply. Now place the Indicator Unit
(Rx) on the wall at desired place and hold it there by hand. Within
5 minute the indicator should get the signal. If It gets the signal,
install the unit as shown in Fig-1. If its unable to get signal, change
the location.
After finding suitable location, drill 2 holes 9 cm apart by a
6mm dia masonry drill bit. Now fix the wall mounting screw with
plastic sleeve in the holes and mount the Indicator Unit.
Steps for installation of Indicator
and level transmitter unit
