168.28
6 5/8"
1/2"N.P.T.
1/2" N.P.T.
99.70
3 15/16"
100.33
3 15/16"
120.90
4 3/4"
148
5 13/16"
1/2 N.P.T.
1/2" N.P.T.
2 7/16" [61.9] Min.
3 1/8" [79.4] Max.
Updated: 09-17-09
1/2” thermostatic valve
The thermostatic valve # 1004 is protected by a plastic protective
covering. It can be used for different functions :
A. It can be used as a rough-in cap for setting the depth of the
valve in the wall. If you look closely at the rough-in cap, you will see
the Min and Max written on it. That means that the thickness of the
finished wall must be in between those two marks, so the valve can
take the minimum depth at 2 7/16” and the maximum depth of 3 1/8”.
The depth recommended is 2 3/4” from the center of the inlet.
Products info: www.aquabrass.com
I N S T A L L A T I O N P R O C E D U R E S
1 HOW TO USE THE ROUGH-IN CAP
#1004
ROUGH-IN
CAP
ATTENTION:
MAKE SURE TO FLUSH THE HOT AND COLD WATER
SUPPLY LINES BEFORE BEGINNING THE INSTALLATION.
3 1/2"
88.90
5 1/2"
139.70
62.2
2 7/16"
Min.
80
3 1/8"
Max.
155.58
6 1/8"
70.04
2 3/4"
99.70
3 15/16"
41.66
1 5/8"
33.02
1 5/16"
71.76
2 13/16"
Ø
41.40
1 5/8"
123.19
4 7/8"
70
2 3/4"
B. The rough-in cap is also used
for the finished wall cutout. This
insures access for servicing the valve
at a future date.
C. The rough-in cap also protects
the valve during installation by
different trades.
TILE
GYPROC
2X4
2X6
ROUGH-IN CAP
SUPPORT
RECOMMENDED
Fig.2
Fig.1
FINISHED WALL
