Aqua HC151+ CI(J), Use And Maintenance Manual

Page: 13 / 36

HC151+ MULTI / HC200+ MULTI
ENGLISH
3.5.1
3.5.2
3.5 PUMP SETUP
Within this menu, you can choose the operating mode that you want to use.
The complete list of available functions is shown below:
This mode allows you to connect the
pump to a pulse emitting water meter.
The pulses coming from the water meter
are multiplied by the set value.
This mode allows the pump to work with
a constant frequency in relation to the
strokes / minute or strokes / hour set.
This mode allows the pump to work
based on the programming of a daily /
weekly timer.
This mode allows you to connect the
pump to a pulse emitting water meter.
The pulses coming from the water meter
are divided by the set value.
This mode allows you to connect the
pump to a pulse emitting water meter.
The pulses coming from the water meter
determine the dosage according to the
ppm, the chemical concentration and the
set ml / stroke.
3.5.4
3.5.3
3.5.5
3.5.6
This mode allows you to connect the
pump to an external mA signal. The
current supplied to the pump (via the
input signal) determines the proportional
dosage according to the two values.