Aqua-Tronics S.D.A.D.II, Operator'S Manual

Page: 7 / 25

2
BATTERIES
SDAD
II
Electronic receiver (UNIT) uses a rechargeable 9.6 V DC NiMh 4.0 AH battery
Battery level is indicated in upper right corner of LCD display. Four green bars
indicate a fully charged battery. One green bar flashing indicates battery must soon
be charged. Install the connector on the supplied smart universal battery charger to
the back cover of the unit and plug the wall cord into any 100 – 240 AC volt supply
for worldwide use.
The battery charger is set at 1.8 amps and should remain at that setting. A small green
LED on the charger will flash slowly if charger is not plugged into the SDAD
II
unit.
The red LED will be on during charging. The green LED will be on when the battery
is fully charged. The red LED will flash when the charger recognizes the battery is
damaged or the voltage is below 6 volts.
ATTENTION
Do not store the SDAD
II
where it is exposed to extremely hot conditions, such as the
window of a vehicle, or direct sunlight on a hot day. The battery could become over
heated. This can reduce battery performance and/or shorten its life.
MICROPHONE WIRELESS TRANSMITTERS ---- RED AND GREEN
A dual mini USB cable is provided to charge the microphone batteries. Plug the USB
cable into the provided 2 port USB wall hub. The mini USB cable plugs are plugged
into the wireless microphone transmitters. The red charge LED will light during charge
cycle and go out when the battery charge is complete.
HEADPHONES
A micro USB charge cable is provided for headphone battery charging. Plug the USB
cable into the two port USB wall hub and the micro USB end into the headphones. A
charging LED is red when charging and will go out when the battery is fully charged.
BATTERY REPLACEMENT
Batteries are not user replaceable. If new batteries are required, please send
instrument to the factory for service.