fitted into the tap entry nut. Tighten sufficiently to avoid
leaking.
1(d)
Using thread tape, wrap the thread of the Purifier
Isolating Tap (16). Remove the Stopper [17(1)] from the
Multi Function Control Valve (17) and screw the Purifier
Isolating Tap (16) into the side outlet port of the Multi
Function Control Valve (17) until it is tight enough so as not
to leak.
1(e)
Reconnect the dishwasher connecting hose to the end of
the Multi Function Control Valve (17) while holding and
supporting the valve with your other hand, to avoid it
loosening on the dishwasher tap or being damaged.
Also, ensure that the Purifier Isolating Tap (16) remains in a
suitable position for ease of operation.
1(f)
If the dishwasher is connected to Hot Water and there is
an optional COLD water dishwasher tap provided, follow
steps 1(c) and 1(d) above. With this option you need to select
which outlet port you want to use for the Water Purifier
connection on the Multi Function Control Valve (17). Either
the end or the side outlet port can be used and you will need
to screw the Stopper [17(1)] into the unused port. This
Stopper has a tapered thread and therefore does not require
the use of thread tape, however, thread tape can be used if this
method is preferred. Tighten both the Isolation Tap (16) and
Stopper [17(1)] sufficiently, to avoid leaking.
Only suitable when the dishwasher is connected to COLD
water.
1(a)
Establish whether the dishwasher is connected to the
cold water supply. This may be achieved by running the
dishwasher on a normal washing cycle and after a few minutes
touching the dishwasher tap or connecting hose inside the
cupboard, if neither feel warm, then the dishwasher is running
on cold water.
Alternatively, turn off the dishwasher tap in the cupboard
(should be by turning clockwise), unscrew the dishwasher
connecting hose from the tap and run water into a container
until you establish whether it is a hot or cold water supply.
CAUTION! IF THE DISHWASHER IS CONNECTED
TO HOT WATER, YOU CANNOT PROCEED TO
CONNECT THE WATER PURIFICATION SYSTEM BY
THIS METHOD.
Check inside the cupboard, for another
dishwasher tap connection, some builders provide both HOT
and COLD tap connections.
If the dishwasher is connected to COLD water or there is an
additional COLD water tap provided, proceed as follows:-
1(b)
Remove the dishwasher connecting hose from the tap.
1(c)
Screw the Multi Function Control Valve (17) onto the
dishwasher tap, ensuring that the Sealing Washer [17(3)] is
Summary of Contents for APRO13212
Page 7: ......
