aqua-pure AP-R05500, Operating And Maintenance Instructions Manual

Page: 3 / 11

Installation, Operation and Maintenance Manual
CAUTION
IMPORTANT NOTES
To reduce the risk associated with property damage due to water leakage:
•
Read and follow Use Instructions before installation and use of this system.
• Installation and Use MUST comply with all state and local plumbing codes.
•
Protect from freezing. Drain filter when temperatures drop below 40°F (4.4°C).
•
Do not install if water pressure exceeds 125 psi (862 kPa). If your water pressure exceeds 125 psi, you
must install a pressure limiting valve. Contact a plumbing professional if you are uncertain how to check
your water pressure.
• Do not install where water hammer conditions may occur. If water hammer conditions exist you must install a
water hammer arrester. Contact a plumbing professional if you are uncertain how to check for this condition.
• The system must be installed on COLD water lines only, maximum temperature is 100°F (37.8°C).
• The system must be installed with the inlet and outlet ports as labeled. Make sure not to reverse connections.
• The disposable filter cartridge
must be replaced every six months or at the specified service cycle.
•
Do not use a torch or other high temperature sources near filter or plastic fittings.
•
Do not install in direct sunlight.
•
Do not install near water pipes which will be in path of a drilling tool when selecting the position to mount
the bracket.
• Mount filter in such a position as to prevent it from being struck by other items used in the area of installation
(waste baskets, etc).
• On plastic fittings, never use pipe sealant or pipe dope. Use thread sealing tape
only.
•
Ensure all tubing and fittings are secure and free of leaks.
• Do not install unit if collet is missing. Contact CUNO if collets are missing from any fittings.
• SHUT OFF FUEL SUPPLY TO WATER HEATER after water is shut off.
• Shut off inlet water supply and depressurize system as shown in manual when changing cartridges or servicing.
• Failure to follow instructions may void warranty.
• Allow a minimum of 7 1/2” (19.5 cm) clear space under filter to facilitate cartridge change.
• Do not crimp copper tubing.
• Some state and local plumbing codes may prohibit the use of saddle-type valves and/or drain connections.
The use of saddle-type valves are prohibited in: Alaska, Delaware, Idaho, Kentucky, Massachusetts, Michi-
gan, Minnesota, New Hampshire, North Dakota, Ohio, Oregan and South Dakota. Check your local plumb-
ing codes for any restrictions that apply.
• It is mandatory that safety glasses be worn during sink hole drilling operations to prevent eye injury.
2 3
Introduction
This manual explains installation and operation of the Aqua-Pure
®
AP-RO5500 Reverse Osmosis (RO) Drinking
Water Filtration System. Please read each section of this manual carefully.
The Aqua-Pure AP-RO5500 RO Drinking Water Filtration System is designed to connect permanently to a home
plumbing system. To ensure that the installation conforms to your state and local plumbing codes, it is recommended
that the installation be performed by a qualified installation specialist for RO drinking water filtration systems or a
licensed plumber.
The RO module is shipped with a preservative solution. Make sure that you flush the system thorough-
ly as directed before the first use.
NOTE: Make sure that the Owners Warranty Record Card is filled out and mailed within 10 days of installation.
Installation Checklist and Table of Contents
1. Determine System Location ..................................................................................................................... 4
2. Prepare the Area for Installation ............................................................................................................... 4
3. Prepare the Filtration System for Installation ............................................................................................ 4
4. Install the Feed Water Valve and Tubing ................................................................................................... 5
5. Prefill and Sanitize the Storage Tank ........................................................................................................ 5
6. Install the Drain Connection ...................................................................................................................... 6
7. Install the Faucet ...................................................................................................................................... 6
8. Make the Faucet Mounting Hole ............................................................................................................... 7
9. Mount the Faucet ...................................................................................................................................... 8
10. Make Initial Faucet Tubing Connections ................................................................................................... 8
11. Install the Purification Assembly and Storage Tank .................................................................................. 9
12. Make Final Tubing Connections ................................................................................................................ 9
13. Install Icemaker Hookup (optional) ......................................................................................................... 10
14. Install Filter Cartridges ........................................................................................................................... 10
15. Start Up the System ............................................................................................................................... 10
16. Installation Troubleshooting .................................................................................................................... 11
17. Maintenance ........................................................................................................................................... 12
18. Parts List ................................................................................................................................................. 14
19. Installation Diagrams (Figures 1-6) ......................................................................................................... 15
20. Limited One Year Warranty ..................................................................................................................... 18
• Failure to follow instructions may void warranty.
IMPORTANT NOTES