Visit: www.aquapulsespas.com.au
BYRON LUXURY SPA HOW TO BALANCE THE WATER
pH
ideal reading is 7.2-7.8.
If your reading is
lower than 7.2
raise the pH by adding
Alkalinity Increaser #4.
26g will raise the pH by 10ppm.
Do not use more than 28g in one day if you are making the adjustment from a 3 in 1
test strips reading.
Accurate pool or spa store readings can apply the recommended dose in one day, test strips reading need to be
retested between doses.
Use a bucket and scoop some of the spas water into the bucket until it is roughly ¾ full, then add the Alkalinity
Increaser #4 to the bucket of water and stir (avoid contact with your skin), once dissolved pour the water from the
bucket into the spa and run jet 1 for 5 minutes.
If you’re reading is
higher than 7.8
lower the pH by using
pH Reducer #6.
26g will lower the pH by 10ppm.
Do not use more than 42g in one day if you are making the adjustment from a 3 in 1
test strips reading.
Accurate pool or spa store readings can apply the recommended dose in one day, test strips reading need to be
retested between doses.
Use a bucket and scoop some of the spas water into the bucket until it is roughly ¾ full, then add the pH Reducer
#6 to the bucket of water and stir (avoid contact with your skin), once dissolved pour the water from the bucket
into the spa and run jet 1 for 5 minutes.
CALCIUM HARDNESS
ideal reading is 250-400ppm.
If you’re reading is lower than 250ppm raise the Calcium Hardness by adding
Hardness Raiser #11.
15g will raise the Calcium Hardness by 10ppm.
Do not use any brand of Test Strips to balance Calcium Hardness.
To balance your Calcium Hardness, you will need to take a sample of your spas water into a pool or spa store for
accurate testing. When you apply the Calcium Hardness required this may make you water go cloudy, don’t panic
it will clear up in a couple of days.
Use a bucket and scoop some of the spas water into the bucket until it is roughly ¾ full, then add the Hardness
Raiser #11 to the bucket of water and stir (avoid contact with your skin), when completely dissolved (this may take
several hours) pour the water from the bucket into the spa and run jet 1 for 5 minutes.
EVERY 4 MONTHS
Replace the Nature 2 Stick inside the spas filter box with a new Nature 2 Stick.
EVERY 6 MONTHS DRAIN THE WATER
Remove the filter and Nature 2 Stick, put 1Kg of
Spa Pipe Flusher #12
into the water before you drain the spa.
Run all pumps for at least 20 minutes, then turn the power supply to the spa off and drain the water. Place your
garden hose in each jet and flush out any residue left in the pipes. Sponge out any remaining water in the spa,
wipe down the complete shell with a soft cloth. Do not use any chemicals.
When refilling the spa make sure that the drain has been closed and place a hose in the filter box to refill the spa
with water. Don’t forget to remove the fitting off the hose.
