Aqua One ProSkim G216, Manual

Page: 4 / 8

4
GB
Installation
1. The pump and associated parts can be found in a
small box. Unpack this box in order to assemble the
pump.
2. Ensure the air intake is attached firmly to the inlet of
the pump.
3. Attach the outlet of the pump to the base of the
inlet pipe. In order to do this, unscrew the threaded
connection, place it over the pump outlet, press the
pump into place and tighten the threaded fitting.
4. Remove the air flow adjustor from the top of the
airline and feed the airline through the airline holder on
the side of the skimmer outlet. Place the airline adjustor
back on the airline.
5. Ensure both outlet taps are fully open (turn anti-
clockwise to open).
6. Place the skimmer in the desired location. The
skimmer can be placed externally, hanging on the
side of the aquarium/sump, or internally in a sump.
The pump must remain submersed at all times during
operation.
7. There is a second airline hose attached to the base
of the collection cup. This is designed to drain the
collection cup into a separate container. Ensure this
airline always drains into a container such as an empty
PET bottle.
8. Switch the pump on at the power outlet. Ensure
the water level does not fall too low, as the aquarium
skimmer will fill with between 2.5-5L (depending on
skimmer model).
9. Adjust the water level using the outlet taps. The water
level will dictate the amount of bubbles that accumulate
int he collection cup. Water level should be checked
daily and adjusted accordingly over the initial run-in
period. For further advice concerning the adjustment
of your protein skimmer, consult your local Aqua One
retailer.
For “wet” skimming (light coloured waste), adjust the
outlet taps so that the water level is high in the skimmer
and substantial amounts of foam are being forced into
the collection cup.
For “dry” skimming (dark, coffee coloured waste),
adjust the outlet taps so that the water level is low and
only small amounts of foam are being forced into the
collection cup.
SPONGES
Remove and rinse the outlet sponges weekly to remove
any accumulated waste.
PUMP
The impeller should be removed and rinsed once a
month to remove any buildup. In the event that there
is significant calcium buildup on the impeller (or any
other part of the pump) it can be soaked in a container
of vinegar for 24 hours.
To access the impeller, turn the base of the pump 90°
and pull it away from the body of the pump. The impeller
sits on a ceramic shaft with rubber grommets at each
end. Ensure all these parts are in the pump when it is
reassembled.
COLLECTION CUP
The collection cup and attached airline should be rinsed
every 2-3 months. Airline should be check regularly for
blockages and replaced if required. After washing the
collection cup, the skimmer should be checked daily
for the subsequent 3-4 days to ensure water level
is correct. Removing the film insode the neck of the
collection cup during maintenance can result in slightly
reduced effectiveness of the skimmer for a few days.
The skimmer can be adjusted until performance is back
to normal.
Maintanence