If you are in any doubt about the electrical
installation or safety of this product you
must consult a qualified electrician.
LIGHT UNIT DOES NOT WORK
1. Ensure switch is in the on position on the top
of the Light Unit.
2. Check light is plugged into power supply and
the switch is on
3. Check the globe is in good condition.
Replace if needed.
POWER HEAD WORKING BUT NO / SLOW
WATER FLOW
1. Check Impeller is in good condition and
replace if needed.
2. Make sure water level in aquarium is above
the Power Head. Please note the Power Head
is a water proof unit.
3. Clean Impeller, Power Head and all Inlet and
outlet pipes.
4. Check that the Spray Bar is inserted correctly
with the end cap at the opposite end to the
elbow.
AQUARIUM POSSIBLY LEAKING
1. Clean filter cartridge as this can create an
overflow.
2. Make sure spray bar holes are pointed down
onto the Carbon Cartridge.
3. Make sure water level is not to high Refer to
Fig 31.
4. If an air stone is being used check it is not
bubbling water over the rim of the aquarium if
so turn the air pump down.
5. Make sure the aquarium is sitting on a level
surface
6. If it is a salt water aquarium remove any salt
creep as it can drain water from the aquarium.
7a. Remove the Light Unit & Filter Unit from the
top of the aquarium. Mark the water level.
Remove any excess water that may be sitting
on the edge of the aquarium. Leave for an hour.
If water level drops proceed to step 7b.
7b. Remove the fish, decorations and gravel.
Empty the aquarium and clean the glass
DO
NOT WASH IN SOAP OR DETERGENT
. Place
a piece of newspaper on a flat level solid
surface. Carefully fill the aquarium ensuring not
to spill any water on to the newspaper. Leave
the aquarium for several hours and then inspect
the newspaper for wet patches.
Trouble Shooting
