English
© 2012 Aqua Lung International
BC
Home
DONNING AND ADJUSTMENT PROCEDURES
1.
Remove the weight pouches from the BC, if applicable.
2.
Disconnect the waist buckle and waistband.
3.
Ensure that the quick release buckles (if equipped) on both torso straps are securely fastened.
While firmly holding the torso strap where it connects to the BC lobe, fully extend each torso strap
to its maximum length by pushing straight up on the slide buckle.
4.
While your dive buddy lifts and holds the BC/cylinder behind you, place your arms through the BC
torso straps as if you were putting on a jacket.
WARNING:
Verify the tension of the cylinder band prior to every dive. Failure to do so may
result in the cylinder slipping during the course of a dive.
5.
Check the cylinder band is secure by pulling on the band while holding down the cylinder at the
valve. If the cylinder band moves, it is too loose. Check the macro adjustment is set for the correct size
cylinder. Repeat steps 1-4 to tighten and secure the cylinder band.
NOTE:
If additional length is needed in the waistband, remove the webbing from the webslides.
