19
52 51
50
49
45
feet
air
outlet
hole
44
46
two threads
NOTE
:
If the poppet bearing does not stay in place,
put a small amount of Christo-Lube
®
on the square
flats and reinsert.
5. Install a new, lubricated inlet fitting o-ring (14) in the
groove located between the wrench flats and shorter threads
on the inlet fitting (62).
6. Take the used LP seat that was removed during disas-
sembly and place it on top of the crown sealing surface in-
side the inlet fitting (62). Place the spring (49) over the stem
of the poppet (50) and set this assembly into the inlet fitting,
on top of the used LP seat.
NOTE
:
the used LP seat is only used to aid in
reassembly. It will be removed and discarded later
in the reassembly procedure.
7. Place the barrel of the valve body (47) over the top of the
poppet. While pressing down on the valve body to compress
the spring, screw the valve body onto the inlet fitting. This
will fully expose the threads of the poppet.
8.
Place the "feet" of the lever (45) into the groove on the
face of the valve body (47) such that the lever is pointing
away and up from the air outlet hole.
9. Place the washer (46) over the threads of the stem.
Thread a new locknut (44) onto the stem. Using a 1/4" nut
driver, tighten the locknut until
two threads
show past the
locknut.
10.
Unscrew the inlet fitting (62) from the valve body. Dis
-
card the used LP seat. While depressing the lever with your
finger, thread the inlet fitting back into the valve body.
11. Attach the valve assembly to the end of the hose until
finger tight. Slowly turn the SEA LV-2 handwheel (10) coun
-
terclockwise to open the valve. If a leak is detected while
opening the valve, immediately close the valve. Loosen the
locknut a 1/2 turn and slowly open the valve again. Repeat
this step until the unit does not leak.
If air leaks when pressurized,
loosen locknut until leak stops
