16
15
6. Remove any blockage.
7. Replace drive pin, propeller and the washer, and
reattach propeller nut.
8. Replace rear grille.
If the Aqua Glider does not work:
1. Check the battery is fully charged, if in doubt of
battery state, recharge the battery until charger
indicates full charged.
2. Make sure the rechargeable battery connector is
connected.
3. Make sure the Master Switch is in the 'On' position.
4. Make sure the battery compartment is dry.
5. Make sure the propeller is not blocked.
Repairing the Inflatable
A repair kit is included in case the inflatable is
accidentally punctured, to repair:
1. Locate the puncture - this can be done by inflating the
inflatable and looking for air bubbles.
2. Deflate the inflatable and make sure it is completely dry.
3. Clean punctured area and dry the area.
4. Using inflatable repair kit apply glue around
punctured area.
5. Use repair PVC sheet, cut so it is 5mm bigger around
the punctured area.
6. Stick the repair sheet on top of the punctured area.
7. Let it dry for 2 hours.
8. Inflate the inflatable and check there is no air leakage
before use.
Maintaining Battery Door Seal
Always keep the Battery Door Seal clean and well
lubricated with silicone grease which can be purchased
from your local hardware store.
Trouble Shooting
