Unscrew inlet and outlet connectors from
AIPRO-20MS
filter housing.
Remove old Teflon tape out of the connectors thread
surface.
Apply several layers of Teflon tape to the connectors
threads.
NOTE! Use only Teflon tape, do not use tow.
NOTE! Apply Teflon tape in the opposite direction to the
direction connectors will be installed.
Disconnect tubing from elbow outlet connected to cartridge
AICRO-20MS.
Proceed as follows:
1) Remove safety clips
2) Symmetrically press quick connector's collar
3) Pull out the tubing
NOTE! Described procedure can be found on page 4,
point 6.2.
NOTE! When pulling out the tubing, use caution to
prevent the tubing from damage. Collapsing of the
tubing may result in damage and future water leaks.
Install (screw in) connectors into new filter cartridge.
NOTE! During installing (screwing in) individual
connectors do NOT withdraw (unscrew) them at any
time. This may result in connection damage and future
water leaks.
Connect tubing with elbow outlet connector attached to
AIPRO-20MS
filter cartridge.
Proceed as follows:
1) Ensure that new filter cartridge is placed in accordance
with the direction of system's water flow.
2) Insert tubing into outlet elbow connector attached to
cartridge
AIPRO-20MS
(correctly inserted tubing is
mounted 1.5 cm deep inside elbow connector).
3) Secure the connection with safety clip.
NOTE! Described procedure can be found on page 4,
point 6.2.
NOTE! When pulling out the tubing, use caution to
prevent the tubing from damage. Collapsing of the
tubing may result in damage and future water leaks.
In order to complete installation of the remaining
replacement cartridges, repeat the procedures
described in points 1-9.
