GETTING STARTED
IMPORTANT NOTE: Fully charge the electric vacuum before using it for the first time.
Charging the battery
NOTE:
It requires an USB charging adaptor (not provided) with a safety output of 5.0V DC and 1.0A.
For EU market, a CE-certificated USB charging adaptor shall be used.
For US and Canada market, limited power source (LPS) or Class 2 type adaptor certificated by North America standards
(such as UL 60950-1, CSA C22.2 No. 60950-1, UL 1310 and C22.2 No. 223) shall be used.
OPERATION
Before immersing the electric vacuum in water, turn the switching knob clockwise until it comes
to a halt (you will hear a ‘click”) to expose the two water-sensing pins and a green dot on the
right side. As soon as both pins make contact with water, the motor will start running. Similarly,
it will stop as soon as the pins are no longer in contact with water.
NOTE: Never attempt to make contact with both pins with anything other than clean water.
CAUTION
•
DO NOT cover the side slot (middle gap) of the electric vacuum during operation, the impeller / motor may be damaged otherwise.
•
Remove the electric vacuum from the pool/spa as soon as cleaning is complete.
CAUTION! Make sure the electric vacuum is always pointing downwards when it is placed into the pool. Otherwise, the pole connector may
be bent and damaged as a result.
To retrieve the electric vacuum from the pool / spa, lift the electric vacuum while pointing it downwards in order to allow water to discharge.
Rinse the electric vacuum with fresh water after every use. DO NOT use any detergent.
1. Place the unit on a flat surface. Turn the switching knob counterclockwise until it stops and completely exposes the charging port.
Align and insert the USB charging cable into the charging port.
2. Connect the USB charging cable to the charging adaptor, then plug the charging adaptor to the power source.
NOTE
•
Charge the electric vacuum completely (about 7-8 hours) before using it for the first time.
•
Always disconnect the USB charging adaptor from the power source as soon as charging is complete.
•
Immediately turn the power off and disconnect the USB charging adaptor from the power source if you detect any of the following conditions:
- Offensive or unusual odor
- Excessive heat
- Deformation, cracks, leaks
- Smoke
1. Connect the USB charging adaptor to the power source. Once the electric vacuum begins charging, the indicator light at the end of the
vacuum will turn red. Normally, it takes about 4.5 - 6 hours to reach a full charge. The indicator light will turn green once the electric
vacuum is almost fully charged.
2. When charging is complete, disconnect the charging adaptor from the power source and unplug the USB cable from the adaptor and
electric vacuum.
Normally, the electric vacuum can operate up to 30 minutes on a full charge (after 4.5-6 hours of charging)
Note: Clean the filter regularly. Excessive debris inside the filter will increase burden to the motor operation and shorten the operating
duration as a result.
NOTE: Rechargeable lithium-ion battery is classified as a consumable item. It has a limited life and will gradually lose its capacity to hold
a charge. Therefore, the running time of the electric vacuum will gradually reduce after repeated charging and discharging throughout its
product life.
NOTE: Let the electric vacuum rest for 30 to 40 minutes before charging it again.
WARNING!
•
Do not use the USB charging cable / USB charging adaptor if any damage is detected.
•
Make sure both the electric vacuum and the charging port are clean and dry before charging them.
•
Refer to the instruction manual of USB charging adaptor (not included) for instructions concerning safety and operation.
