Aqua Creek PRO SPA 40, Assembly Instructions Manual

Page: 2 / 21

2
ASSEMBLY INSTRUCTIONS
The lift arrives mostly assembled on a crate. Begin by locating all parts for your lift in the parts
lists below. Refer to page 4 for parts identification.
PARTS LIST
CRATE 1
1. SPA LIFT ASSEMBLY
ITEMS INCLUDED WITH SPA LIFT/ PRO SPA 40 LIFT
1. (1) 24V BATTERY
2. (1) BATTERY CHARGER
3. (1) HAND CONTROLLER
4. (1) SEAT BELT
5. (1) HARDWARE BAG
TOOLS NEEDED:
3/4" Wrench Drill
Hammer Marker/Chalk
1 1/8" Masonry Bit Epoxy or Hydraulic Cement
1.) Locate the 24v battery and wall mount battery charger. Batteries arrive from the factory
partially charged. Charge the battery for 24 HOURS before initial use of the lift .
Determine the location that you want to position the wall mount charger (next to a 110v
AC outlet), and fasten it with the supplied screws. Plug in the charger to the outlet.
2.) Clip the battery to the charger and allow the battery to charge. When the battery is
correctly mounted to the charger, the CHARGE light will illuminate. When the battery
is fully charged, the CHARGE light will GO OFF.
3.) If the anchors have already been installed at this point, skip to page 4. If the anchors
have not already been installed, follow the anchor installation instructions on page 3.
HARDWARE BAG
ITEM # QTY. DESCRIPTION
PART USE / LOCATION
1 3 4” DUAL THREADED ANCHOR ANCHOR
2 3 1/2” x 1-1/2” HEX HEAD BOLT S.S. STANDARD ANCHOR BOLT
3 3 1/2” FLAT WASHER S.S. ANCHOR BOLTS