Copyright © 2017 Aqua Creek Products All Rights Reserved
Revised 1/5/17
1.
Attach seat belt to the seat.
SEE FIGURE D
2.
Install the Pro Pool-AT pool lift onto the four (4)
anchors using the supplied 1/2 inch x 1 1/2 inches
stainless steel hex-head bolts and 1/2 inch stainless steel
flat washers. Make sure all bolts are tight before using
the lift.
SEE FIGURE E
3.
Before installing the battery, place it on the charging
unit and let it charge for 24 hours. Make sure the orange
“charge” light illuminates when the battery is being
charged.
4.
Remove the fully charged battery from the charger,
grease the terminals, and install it on top of the control
box. The battery will line up with the control box, and
will ‘click’ when it properly locks in place. The lift will only
operate when the battery is correctly mounted.
WHEN NOT IN USE, STORE THE
BATTERY ON THE CHARGER!
Pro Pool-AT Assembly Instructions
LOOP ON TOP
FOR EASY ACCESS
THREAD THROUGH
SLOTS AND PINCH
TOGETHER TO HOLD
FIGURE D
ANCHORS (4)
INSTALLED FLUSH
W/DECK SURFACE
ATTACH
FULLY-CHARGED
BATTERY
CONTROL BOX
1/2" X 1-1/2"
HEX BOLT (4)
1/2" FLAT
WASHER (4)
POOL
WALL
HANDSET
PLUGS INTO
CONTROL BOX
FIGURE E
8
