Copyright © 2018 Aqua Creek Products All Rights Reserved
Revised 11/21/18
Titan Assembly Instructions
3/8" NYLOCK NUT (2)
3/8" FLAT WASHER (2)
SEAT ARM
1/2" X 3"
SHOULDER
BOLT (2)
CONTROL ARM
LIFTING ARM
STEP 4: INSTALL SEAT ARM
Locate the SEAT ARM and the following hardware:
•
(2) 1/2” x 3” SHOULDER BOLT
•
(2) 3/8” FLAT WASHER
•
(2) 3/8” NYLOCK NUT
Install the SEAT ARM at the ends of the CONTROL
ARM and LIFTING ARM as shown in the fi gure to the
left. Tighten the NYLOCK NUTS until snug as shown in
PHOTO 4. DO NOT OVERTIGHTEN!
(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM
THE MAIN ASSEMBLY)
STEP 5: ADJUST THE SEAT POSITION
The SEAT ASSEMBLY will arrive attached to the SEAT ARM
adjusted to its highest position. To adjust the SEAT ASSEMBLY
to a lower position remove the hardware as shown below.
Slide the SEAT ASSEMBLY to its desired position (in 4 inch
increments) and reinstall the hardware. The maximum
adjustment is 16 inch (down).
DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS
– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE
SEAT ASSEMBLY TO THE CHAIR ARM!
NOTE: For most applications, such as pools with a fl at deck,
the seat will be installed in its lowest position. For applications
where a wall or curb must be cleared the seat should be
installed in a higher position. In its highest position the seat
will clear a 26 inch [660mm] high wall (with the pull-out
legrest).
STEP 4
MAIN
ASSEMBLY
SEAT-ARM
HOLES AT 4"
INTERVALS
ALLOW FOR
ADJUSTMENT
OVER 16"
RANGE
SEAT ASSEMBLY
ADJUSTED TO
LOWEST POSITION
(SEAT WILL ARRIVE
AT HIGHEST
POSITION)
STEP 5
5/16" NYLOCK
NUT (2)
5/16" FLAT
WASHER (3)
5/16" X 4 1/2"
HEX BOLT
3/8" X 2"
SHOULDER BOLT
7
