Copyright © 2020 Aqua Creek Products All Rights Reserved
Revised 6/25/20
BASE WELDMENT
MAST ASSEMBLY
3/8" NYLOCK
NUT (4)
3/8" FLAT
WASHER (4)
FIGURE 3
LIFTING ARM
MAST ASSEMBLY
1/2" X 3"
SHOULDER BOLT
3/8" NYLOCK
3/8" FLAT WASHER
LOWER ATTACHMENT
POINT
ACTUATOR
MOUNTING
TABS
FIGURE 4
3/8" X 1 1/4"
SHOULDER BOLT
5/16" NYLOCK
5/16" FLAT WASHER
5/16" FLAT WASHER
5/16" NYLOCK
3/8" X 2"
SHOULDER BOLT
LIFTING ARM
MAST ASSEMBLY
ACTUATOR
FIGURE 5
Spa Lift Ultra Installation and Assembly
1.
Once the anchor inserts have been installed, the base weldment can now be secured to the deck using the 1/2
inch hex bolts and washers. See FIGURE 2.
2.
Attach the mast assembly to the base, as shown in FIGURE 3, using
the 3/8 inch nylock nuts and fl at washers. This may require two people.
SPA LIFT
BASE WELDMENT
1/2" X 1 1/2"
HEX BOLT (3)
1/2" FLAT
WASHER (2)
1" X 8" ANCHOR
INSERT (3)
1/2" EXTERNAL
TOOTH WASHER (1)
FIGURE 2
3.
Attach the lifting arm (identifi ed by the two actuator mounting tabs opposed to the control arm which has
no tabs) to the mast assembly using the 1/2 inch shoulder bolt and 3/8 inch nylock and fl at washer. Be sure the
actuator mounting tabs on the lifting arm are facing downward. See FIGURE 4.
4.
After the lifting arm is secured to the mast, attach the actuator to the mast and the lifting arm with the 3/8 inch
shoulder bolts and 5/16 inch nylocks and fl at washers as shown in FIGURE 5. Make sure the actuator head faces
the opposite direction of the control box. If rotated the other way, the actuator head might hit the mast.
5
