Copyright © 2017 Aqua Creek Products All Rights Reserved
Revised 9/15/17
CLIP PIN (2)
3.
Install the spineboard attachment with the supplied clip pins as shown. Loop safety clips around
the back of the attachment tube and clip over the ends of the pins to keep them from slipping out
of the holes.
Operating Instructions
1. To load/unload the spineboard, rotate the tie-down clamps down, This allows the spineboard to slip
over the forks without interference.
2. Slide the spineboard under the hold-down bracket to ensure stability.
3. Make sure the forks are between the plastic blocks under the spineboard as shown at the bottom of
the following page (bottom view). This will keep the spineboard from sliding side to side.
4. Rotate the tie-down clamps up to capture the spineboard. Thread a tie-down strap through the top
hole and loop the strap around one of the spineboard handles. Loop the strap through itself and over
the top of the clamp. Loop the end over the strap as shown. Repeat for the second strap.
NOTE: The forks must be between the plastic blocks of the spineboard with the spineboard positioned as
shown at the bottom of the next page. DO NOT USE THE SPINEBOARD ATTACHMENT WITHOUT THE TIE-
DOWN STRAPS OR WITH THE PLASTIC BLOCKS REMOVED!
3
