AQUADUCT ECO
•
A complete cooling circle consists of the aquaduct and one wa-
ter cooler at the minimum.
5. Use of the plug&cool connectors
5. Use of the plug&cool connectors
5. Use of the plug&cool connectors
5. Use of the plug&cool connectors
Our plug&cool connection system makes a secure fit-
ting of the hoses possible without any tools. It is pres-
sure and temperature resistant. Please observe the fol-
lowing instructions for the fitting:
1. Cleanly cut the hose to the desired length.
The hose should be cut evenly
evenly
evenly
evenly and cleanly avoiding
avoiding
avoiding
avoiding
burs
burs
burs
burs with a sharp knife or a hose cutter (available in
our shop). After each detachment of the hose from a
connector the first two centimeters have to be cut off to
guarantee a secure operation.
2. Insert the hose into the connector up to the limit
stop.
When inserting the hose, a first limit stop will be felt
which has to be overcome with some effort. If you want
to be on the safer side, you can mark the hose with a
felt tip pen up to where you have to insert it. Depending
on the connector it will be between 18 and 20 mm.
If the hose has to be detached, please do
the following:
1. Push down the black or blue plastic ring
on the connector. For this purpose you
can also use the separately available AC
Multi-Tool. Slip it over the hose with the
middle opening.
2. While pushing down
While pushing down
While pushing down
While pushing down pull the hose from
the connector.
© 2007-2016
Aqua Computer GmbH & Co. KG
- 9 -
Gelliehäuser Str. 1, 37130 Gleichen, Germany
10
0
20
1
2
