Apxalarm APX32, User Manual

Page: 37 / 64

– 37 –
USER FUNCTIONS
Remote Phone Control Feature
Enter:
(within eight seconds)
Your user code
Upon entering remote phone control mode the APX32 will announce “System, enter code”.
Remote Phone Control Commands
To remotely disarm system:
+ [1]
Your user code
To remotely arm in AWAY mode:
+ [2]
Your user code
To remotely arm in STAY mode:
+ [3]
Your user code
To remotely arm in AWAY or STAY mode with no delay:
+ [2] or [3] + [0]
Your user code
To remotely activate X10 devices 1-6:
[#] + [4] + device no.
To remotely activate X10 devices 7 & 8:
+ [#] + [4] + device no.
Your user code
To remotely deactivate X10 devices 1-6:
[#] + [7] + device no.
To remotely deactivate X10 devices 7 & 8:
+ [#] + [7] + device no.
Your user code
To remotely Bypass zones:
+ [6] + zone no.
Your user code
To remotely activate Forced Bypass:
+ [6] + [#]
Your user code
To remotely check system status: [
✻
]
To end remote phone session:
Hang Up or + [9]
Your user code
NOTES : (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been bypassed.