APW Wyott X TREME-1 Installation And Operating Instructions Manual Download Page 4

4

2 . GENERAL INFORMATION

1.  Overall Dimensions w/Wire Feeder - 13.610”H (34.5cm) x 15.192” W (38.6cm) x 17.982” D (45.7cm)

2.  Product Opening - 1.50”H (3.8cm) x 10.50” W (26.7cm)

3.  Electrical Requirements (Single phase):

A.  120 Volt, 1800 Watt, 15 Amp.

B.  208 Volt, 1800 Watt, 8.5 Amp.

C.  230/240 Volt, 1800 Watt, 7.8 Amp.

D.  Cordset configuration

1.  Each toaster equipped with three wire grounded cordset and standard three-prong plug.

2.  In the U.S.: 120V uses NEMA 5-15P. 208, 230/240V uses NEMA 6-20P.

3.  In Canada: 120V uses NEMA 5-20P.

4.  Net/Shipping Weight – 28 lb.(12.7kg) / 33 lb.(14.97kg)

3 . INSTALLATION INSTRUCTIONS

1.  Check Contents - refer to Figure 1, account for the following parts:

A.  Wire Feeder - inside Reflector Tray

B.  Reflector Tray - shipped in place

C.  Toast Drawer - shipped in place

D.  Instruction Manual - shipped loose

2.  Position Wire Feeder

A.  Pull out Reflector Tray

B.  Rotate Wire Feeder 

C.  Slide Reflector Tray back

D.  WARNING: Operating toaster without Reflector Tray reduces toasting capabilities.

3.  Toaster Placement

A.  Locate toaster near a grounded receptacle of the proper configuration (see below). Plug the 

cordset directly into receptacle (DO NOT USE AN EXTENSION CORD).

1.  In the U.S.: 120V uses NEMA 5-15R. 208, 230/240V uses NEMA 6-20R.

2.  In Canada: 120V uses NEMA 5-20R.

B.  Place toaster on flat surface providing following minimum clearances:

1.  Base = one inch (provided with legs installed).

2.  Side and back walls = two inches

3.  Overhead = Enough space to allow adequate heat displacement.

C.  Position toaster where customers will not contact any surface labeled “CAUTION HOT”.

CAUTION:

 Use only non-abrasive cleaners. Abrasive cleaners could scratch the finish 

of your unit, marring its appearance and making it susceptible to dirt accumulation.

WARNING:

 Failure to provide clearances will cause unit failure and invalidate 

warranty claims (see installation instructions).

NOTICE:

 Do not use toppings (butter, etc.) on product as product is inverted during 

normal operation.

NOTICE:

 Operating toaster without legs invalidates any warranty claims.

NOTICE:

 Neglecting to keep fan opening clean could result in toaster failure.

Summary of Contents for X TREME-1












Reviews: