5
3. GENERAL INFORMATION
Check the rating label for your model designation and electrical rating. The Rating Label is located on the
bottom front of the control panel.
Overall dimensions with feeder:
M952: 208VAC, 2780W, 13.4Amps, 60Hz or 240VAC, 2780W, 11.6Amps, 60Hz
208/250V: NEMA6-20P Plug, 4 foot, 3 wire grounded cord.
If the supply cord is damaged, the manufacturer or an authorized service agent or a similarly qualified
person must replace it to avoid a hazard or warranty.
97 lbs (44.1Kg)
Electrical ratings:
Cordset Configuration:
Shipping Weight:
25 15/16” x 23 1/2” x 17 1/2”
4. INSTALLATION
1.
Examine carton for damage.
A. Apparent damage or loss must be noted on the freight bill at the time of delivery.
must sign
B. Concealed damage or loss if not apparent until after the toaster is removed from carton,
Be sure to save all contents and packaging material.
2. Verify Parts
NOTE:
3.
Assemble Legs
The freight carrier has assumed responsibility for its safe transit and
delivery. If equipment is received damaged, either apparent or concealed, a claim must be made
with delivering carrier.
The
carrier representative (Driver)
the freight bill. If this is not done, the carrier may
refuse the claim. The carrier can supply the necessary forms.
a request for inspection must be made to the carrier within 15 days. The carrier should arrange
an inspection.
After removing unit from the shipping carton, unwrap loose parts and remove any packing tape,
plastic wrap and nylon tie-down. Verify the following parts:
Legs
In plastic bag
4
Butter Roller
In individual carton
1
Conveyor
In individual carton
1
Instruction Manual
Loose in carton
1
PRIOR TO INITIAL START-UP, ALL REMOVABLE PARTS AND THE GRILL SURFACE
SHOULD BE CLEANED WITH WARM SOAPY WATER TO REMOVE MANUFACTURING OILS,
THEN RINSED AND DRIED THOROUGHLY. Apply oil (vegetable oil) to the conveyor chain after
washing. (Bun oil can be used if it contains no animal fats, salts, or dairy products.)
Lay the toaster on its back and install the four adjustable legs into the threaded holes on the bottom
of the toaster. Hand tighten the legs by gripping the steel shank and turning until it is seated firmly
against the bottom of the toaster. Set the toaster upright on a flat surface. Unscrewing the lower,
chrome insert of each leg levels the unit. Flats are provided to allow use of a wrench. “Precise”
leveling is not required for proper operation.
Item
Packaging
Qty
4.
Conveyor Installation
Remove the top and bottom control panels by lifting it straight up. (See Figure 1) Lift conveyor
assembly
by using U shaped handles on each conveyor side bracket. Lower the
conveyor into the two conveyor hanger brackets
above the grill plate on each side, so the
four spacers on the sides of the conveyor rest on the bottom flange and the bottom spacers are
against the adjustment screws. The conveyor hanger brackets
are factory adjusted.
However, before reinstalling the front panels apply power to the unit and run the conveyor to insure
proper gear engagement. If gears are not properly engaged adjust the conveyor by loosening the
jam nuts on the conveyor hanger brackets and adjusting the screw (see Figure 2) to set the
conveyor to the correct height. Re-tighten jam nuts after adjustment is complete.
2
2
1
