For 2007-2014 Ford Edge (Excl. Sport & Eco-Boost Model)/
2007-2015 Lincoln MKX (Excl. Eco-Boost Model)
*Will not work on vehicles equipped with power retracting boards.
REV: 20190401
Page 1 of 2
PARTS LIST:
Item QTY
Description
Item
QTY
Description
#1
2
Driver/ Passenger Side Bar
#8
4
Plastic Washer
#2
1
Driver Front Mounting Bracket (DFM)
#9
2
M10x1.5 Nut Plate
#3
1
Passenger Front Mounting Bracket (PFM)
#10
2
M10x1.5 - 30 Hex Bolts
#4
1
Driver Rear Mounting Bracket (DRM)
#11
8
M10 Flat Washer
#5
1
Passenger Rear Mounting Bracket (PRM)
#12
8
M10 Lock Washer
#6
4
2-Hole Support Bracket
#13
8
M10X1.5 Hex Nuts
#7
2
M10x1.5 J-Bolt
#14
8
M10X1.5-75 Carriage Bolts
PROCEDURE:
1.
Verify all parts are present. Read and understand instruction before beginning.
2.
Determine passenger and driver brackets.
3.
Thread M10 hex head bolt through
Nut Plate
, insert into outer hole, and use a plastic washer to hold in
place. Insert J-bolt into inner hole and use a plastic washer to hold in place.
(Fig 1)
4.
Attach front passenger side bracket to the previously assembled M10 bolt plate and “J” bolt using two
M10 flat washers, M10 lock washers, and M10 hex nuts as shown.
(Fig 1)
5.
Remove the two foremost factory bolts from the rear suspension bracket. Slide bracket into place and
secure using factory bolts.
(Fig 2)
6.
Select the
Driver Side Bar
. Slip (2) M10X1.5-75 Carriage Bolts into each 2-Hole Support
Brackets ,and insert the 2-Hole support bracket into the
Driver Side Bar
.
(Fig 3)
. Carefully
position the
Bar
onto the (2) Mounting Brackets. IMPORTANT: Do not slide the
Bar
on the
Brackets or damage to the finish may result. Attach the
Driver Side Bar
to the Mounting
Brackets with (2) M10 Hex Nuts,(2)M10 lock washers and (2)M10 flat washers,
(Fig 4)
. Do not
tighten hardware.
7.
Level and adjust the
Bar
properly and tighten all hardware.
NOTE: Torque all M10 X1.5-75
Carriage Bolts to 22~25 Ib-ft. Don't over tighten,or the aluminum square bars will be
damaged by the brackets.
8.
Repeat Step 2-6 for the other side installation. Installation completed!!!
(See Fig 5)
9.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect
the finish with a non-abrasive automotive wax, (e.g.Pure Carnauba ) on a regular basis. The use of any soap,
polish or wax that contains an abrasive is detrimental, as the compounds scratch the finish and open it to
corrosion.
2-Hole Support Bracket
PRM
DFM
PFM
DRM