Page
8
Set-Up and Operation
Unpacking
To unpack the
HEPA-FLOW
™
APS625, complete the following steps:
1. Check the shipping box for damage. Call
Air-Pure Systems
- and the shipping company —
right away if any damage is evident.
2. Remove unit off of pallet, stand the shipping box upright, open it, remove packing materials
and wheel unit out.
3. Check the unit for physical damage. Call
Air-Pure Systems
immediately if any damage is
present.
4. Verify the contents of the shipment against the packing list.
5. Record serial number from back of unit onto the manuals or other place of reference.
Packing List
1. APS625 with HEPA Filter, UV Lamp, and Prefilter installed in unit (the UV Lamp and
Prefilter are not visible without opening the unit).
2. 2 Manuals
3. 2 Service Keys
4. 2 Operator’s Keys
5. UL Listed Hospital Grade Cable
6. Certificate of Performance
Call (952) 226-1112 to report any damage during shipment or missing parts.
Room Requirements
The
HEPA-FLOW
™ APS625 requires a standard 110-volt, 60-Hz, three hole grounded
electrical outlet on a 15-amp (minimum) circuit. (A 220-volt, 50Hz model is also available.)
The unit comes with an UL Listed Hospital Grade Cable (part no. 14-6066).
WARNING: Do not use an adapter with an ungrounded two-hole outlet to
connect this unit. If necessary, call an electrician to update your electrical
plugs and/or circuitry to accommodate the unit.
If the room needs to be pressurized, an opening to air outside the room is also
required. See "Equipment Options" in the Appendix for accessory products
designed for use in pressurizing the room.
Set-Up Procedures
1. The APS625 is a freestanding floor unit that can be rolled easily to the desired
position in the room. The negative pressurization kit can be installed on any of the
different options. See Equipment Options section of Appendix for different types of
units.
