CFS100 SERIES OPERATION MANUAL
SECTION 6: FRONT PANEL OPERATION
Entire Contents Copyright
2016 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CFS100 Series Power Source Operation Manual
Page 57 of 146
6
Front Panel Operation
This Chapter provides an overview of front panel operation for the CFS100 Series power
sources. For remote control operation, refer to Section 7 “Remote Control Programming” of
this manual for an overview of available programming commands.
6.1
Powering On
The power source can be turned ON using the power toggle switch located on the left hand side of
the front panel. (See Section 6.2, “Front Panel Layout“) A splash screen will appear as shown below.
After several seconds, the LCD will display the Setup (Set) screen. The actual screen will
differ somewhat with the operating mode that was selected when the unit was turned off.
(PROGRAM, MANUAL or DC).
6.2
Front Panel Layout
The front panel layout is shown in Figure 6-1 below. The number of buttons is kept to a
minimum to ensure simple front panel operation for casual and experienced users alike. The
shuttle knob is used to slew parameter values while in Test (Output ON) mode of operation.
Figure 6-1: CFS100 Series Front Panel Displays and Controls
The following controls and indicators are available for use.
Item
Description
Purpose
1
Power ON / OFF Switch
Turns AC input power to the unit on or off. The ON
position is marked “|”. The OFF position is marker
Summary of Contents for CFS108
Page 145: ......
