For 2005-2019 Toyota Tacoma Double/Crew Cab
REV: 20190401
Page
2
of
3
result. Attach the Driver Side Bar to the Mounting Brackets with (2) 10mm Hex Nuts,(2)10mm lock
washers and (2)10mm flat washers,
(Figure 10)
. Do not tighten hardware.
7.
Level and adjust the Bar properly and tighten all hardware.
NOTE: Torque all M10 X1.5-75
Carriage Bolts to 22~25 Ib-ft. Don't over tighten,or the aluminum square bars will be
damaged by the brackets.
8.
Repeat
Steps 2—7
for passenger side installation.
NOTE: The Passenger Center location use the
same Mounting Bracket as Drive Rear Mounting Bracket. The Passenger Rear location use the
same Mounting Bracket as Drive Center Mounting Bracket.
9.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
FINISH PROTECTION
Products have a high quality finish that must be cared for like any other exposed finish on the vehicle. Protect the finish
with a non-abrasive automotive wax, (e.g.Pure Carnauba ) on a regular basis. The use of any soap, polish or wax that
contains an abrasive is detrimental, as the compounds scratch the finish and open it to corrosion.
Driver/Passenger Side Installation Pictured