APRILIA RST FUTURA - 2001, Service Manual

Page: 6 / 358

RST mille
USA
INTRODUCTION
0
- 6 -
00
Release 00/2002 - 03
0.2 HOW TO CONSULT THE MANUAL
1) Vehicle (or engine) model
2) Section
3) Progressive release number (“00” refers to the first
edition)
4) Year and month of Release publication
5) Section number
6) Section page number
7) Updated progressive page number
8) Chapter title (progressively numbered)
9) Paragraph title (progressively numbered)
10) Description of the operation (always preceded by a
diamond)
11) Description of the operation: an asterisk means the
operation must be repeated on the opposite side of
the vehicle
RST mille
GENERAL INFORMATION
1.9 PLACING THE VEHICLE ON THE SUPPORT
STANDS
1 - 17 -
00
Release 00/2001 - 07
1.9.1 PLACING THE VEHICLE ON THE FRONT
SUPPORT STANDS
Place the vehicle on the central stand.
Place the vehicle on the appropriate front support stand ,
see 1.9.1 (PLACING THE VEHICLE ON THE FRONT
SUPPORT STAND).
At the same time, insert the two pins (1) of the stand
(3) into the two holes (2) at the bottom of the front fork.
PLACING THE VEHICLE ON THE CENTER
SUPPORT STAND
3
1
2
1.9.2
Carefully read 0.5.1 (PRECAUTIONS AND GENERAL
INFORMATION).
Code 8140176 (complete stand).
Remove the lower fairing, see 7.1.33 (REMOVING THE
LOWER FAIRING).
Hold the internal nut (1) steady in place.
Unscrew and remove the upper right rear engine
fastening screw (2).
Tightening torque nut (1) / screw (2): 50 Nm
(5.0 kgm).
IMPORTANT
The screw (2) on the left side is longer.
Retrieve the nut (1).
Insert the upper right support pin (3) in the upper hole
on the right-hand side.
Insert the stud bolt (4) in the upper hole on the left-hand
side, and screw it all the way onto the pin (3).
Screw the upper left support pin (5) all the way onto the
stud bolt (4) and tighten.
Hold the internal nut (6) steady in place.
Unscrew and remove the lower engine fastening screw (7).
7
2
1
6
5
4
3
Rest one foot at the front of the stand (3).
Push the stand (3) all the way down.
USA