pag.
10
Table B
Default settings
Key of the functions that can be programmed in:
Buzzer = acoustic signalling of the arming and disarming of the alarm system.
Blinker = visual signalling of the arming and disarming of the alarm system
Buzzer
Blinker
Buzzer
Blinker
ONE PRESS OF THE BUTTON
TWO PRESS OF THE BUTTON
YES
YES
NO
NO
1
2
1
2
YES
YES
REMOTE CONTROL PROGRAMMABLE FUNCTIONS
The manufacturer prepares the alarm system with standard settings (see table B).
You can alter its settings to meet your particular needs by following the procedure below:
1)
Arm the system using the remote control.
2)
Turn the ignition key to the ON position (+15). The alarm system will respond with an acute acoustic
sound (beep).
3)
Press button A on the remote control four times within 10”. Every time you press the button you should
see the direction indicators flash.
After you have pressed the remote control button for the fourth time, the alarm system will emit four flat
sounds (boops) confirming it has entered programming mode. You can now select the function required.
4)
Turn +15 on and off until you reach the number of the function required (see table A), e.g. Blinker - switch
+15 off and on twice. The LED switches on every time +15 is on to facilitate counting.
5)
K15 on, press button A once if you want to select the setting shown in the left hand column;
press button A twice if you want to select the setting shown in the right hand column.
6)
15 off and repeat the procedure from step 4 if you want to change any other settings.
IMPORTANT:
after you have programmed in a setting, the counter always starts again from the first function.
7)
Four fast buzzer sounds confirm the end of programming;
8)
Press button A on the remote control once when the key is in the OFF position to exit programming mode
altogether.
Table A
Programming
