STEP 2. DISASSEMBLE THE CONTROL
STEP 3. MOUNT THE CONTROL ON THE WALL
• There are two mounting screws and two drywall anchors provided with the control. See
Figure 2
.
IMPORTANT…
1. Route wires through square hole in backing plate. Level backing plate against wall and mark two of
the mounting holes.
2. Drill two 3/16” diameter holes at the marked locations and install drywall anchors (included). Drywall
anchors should be used unless installing on paneling or other hard surfaces. Anchors should be flush
with the wall surface. (Note: Mounting holes on backing plate are designed to fit on a horizontal J-box.)
3. Secure the backing plate to the wall using the two screws (included). Make sure all wires extend
through the square hole in the backing plate.
PULL AP
ART
BACKING PLATE
FRONT COVER
Figure 1 – Disassemble the Control
ANCHOR
BACKING PLATE
SCREW
Figure 2 – Mount the Control
• Carefully remove the front cover from the backing plate. See
Figure 1
.
