Applifast Fein ABSU12 Series, Manual

Page: 15 / 24

15
en
For your safety.
Read all safety warnings and all
instructions.
Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have
thoroughly read and completely understood this
Instruction Manual and the enclosed “General
Safety Instructions” (document number
3 41 30 465 06 0). The documents mentioned should
be kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.
Intended use of the power tool:
Hand-held cordless drill/driver for screwing in and
unscrewing screws and nuts, and for drilling and screw-
driving in metal, wood, plastic, ceramics, as well as for
tapping in weather-protected environments without
water supply using the application tools and accessories
recommended by FEIN.
Safety warnings for drills.
Safety instructions for all operations.
Hold the power tool by insulated gripping surfaces,
when performing an operation where the cutting acces-
sory or fasteners may contact hidden wiring or its own
cord.
Cutting accessory contacting a “live” wire may
make exposed metal parts of the power tool “live” and
could give the operator an electric shock.
Drilling diameter, wood
Drilling diameter, stone
Chuck clamping range
Screw diameter
Weight according to EPTA-Procedure 01
Low speed
High speed
Reduce torque
Increase torque
(**) may contain numbers and letters
Character Unit of measurement,
international Unit of measure-
ment, national Explanation
U
V V DC voltage
f
Hz Hz Frequency
n
0
/min, min
-1
, rpm, r/min rpm No-load speed (with fully charged battery)
n
S
/min, min
-1
/min Impact rate
M...
Nm Nm Torque (hard/soft screwdriving application)
Ø mm mm Diameter of a round part
L
pA
dB dB Sound pressure level
L
wA
dB dB Sound power level
L
pCpeak
dB dB Peak sound pressure level
K... Uncertainty
m/s
2
m/s
2
Vibrational emission value according to
EN 62841 (vector sum of three directions)
h,D
m/s
2
m/s
2
Mean vibrational value for drilling in metal
h
m/s
2
m/s
2
Arithmetic mean value of the vibration total
values
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
min, m/s
2
Basic and derived units of measurement from
the international system of units
SI .
Symbol, character Explanation
WARNING
applifast.com
Toll Free 1 800 563 1293