3
3
Cable Connections
Connect the 4pin multi cable to the Right and Left speakers. Connect the power cable to the inlet
located on the speaker labeled
R – right.
Connect the Audio source to the Right speaker next, using the following input options; 2 x XLR
and ¼-inch TRS Balanced Combo-Jacks (Left/Right), or the Stereo 1/8-inch TRS Jack. Last, the
speakers can be used with any Bluetooth™ capable device for Wireless Streaming.
To Obtain The Best Performance With The RM5
Bluetooth Operation
When connecting to the unit for the first time, press and hold the Bluetooth™ switch for 4 sec-
onds. Once the Bluetooth™ LED starts to flash, a new device will be able to connect to the RM5.
When turning the unit on, the RM5 is in Bluetooth™ Linkback mode by default, which attempts to
connect to previously connected devices.
If you would like to turn Bluetooth off, tap the Bluetooth™ switch once. To turn the Bluetooth™
back on, simply tap the Bluetooth switch again.
Standby Operation
When the power is applied to the speakers and power button is not engaged (up position) and dis-
playing red, the Standby mode is engaged.
Sleep Mode
Then with power applied and the power button engaged (down position) and displaying green, the
Standby mode is activated after 20 minutes with no signal from any of the inputs. When this oc-
curs, the microprocessor establishes the following:
• The amplifier inputs are muted
• The DSP is put into a low power reset mode
• The main transformer is disconnected from the supply
• There is an audible Standby mode confirmation 'Click' from the speaker
• The power switch LED displays a slow green flash
While in Sleep mode, the microprocessor monitors all inputs and the Bluetooth module for a sig-
nal. If any signal is detected, the above steps are reversed and the unit becomes active.
