Applied Biosystems GeneAmp PCR System 9700, User Manual, Page: 38 / 132

3-10 Instrument Setup
Turning the
Run-Time Beeper
On or Off
When turned on, the run-time beeper beeps during a pause and once at the
completion of a run. The default value is Off.
Setting the Pause
Time Out
The Pause Time Out field sets the time in minutes:seconds format for the length of a
pause when you use the Pause soft key to pause a run from the Run Time screen. For
more information on Pausing a Run, see “Pausing a Run” on page 4-8.
To turn the Run Time-Beeper on or off:
Step Action
1 Select the Run Time Beep field. This changes the value of the soft keys.
2 You can take the following action:
3 Press
Enter
to accept your entry.
If you want to... Then...
turn the beeper on Press ON.
turn the beeper off Press Off.
To set the pause time out:
Step Action
1 Select
More
to display the second configuration screen.
2 Set the
Pause Time Out
field by using the numeric keys to enter a time in minutes
and seconds.
From this screen, you can also define the:
♦
Idle state setpoint temperature.
♦
Baud rate for your printer port.
3 Press Accept when all information on this screen is correct.
Note CE clears an entry.
Instrument Configuration
Pause Time Out: 10:00 (00:01-99:59)
Idle State Setpoint: 25.0°C (4.0-99.9)
Baud Rate: 9600
F1 F3 F4 F5 F2
Accept Cancel More